Sight mount screw sizes - recurve and compound

mbaker74

Supporter
Supporter
AIUK Saviour
Does anyone know if the sight mounting block to riser screws are the same size for a recurve and a compound?
trying to see if I can use an old recurve sight on the club demo compound bow, it's not used enough to warrant buying a new compound specific sight for it.
 

caspian

Member
from the AMO Standards: http://www.outlab.it/doc/amostd.pdf

AMO BOW SIGHT & ACCESSORY
MOUNTING HOLES STANDARD
Two holes located on the outside of the bow window are to be 10-24 threaded holes spaced 1.312 +- .010 center to center. Minimum thread depth shall be .250. Mounting holes in sights or other side mounting accessories should conform to these dimensions. A line through the axis of the holes shall be parallel to the bowstring.
 
Top