WAs helping one of the girls set up a new Shibua dx button today and came up with a bit of an issue.
She's an experienced shooter, doing 550 portsmouths. She is quite small, so shoots 40lb Hoyt limb she but only draws 32lb. She is currently shooting ACC's in1500 spine..
we checked centre shot and sight positioning, all fine. Started with the button at a stiff setting, arrows 2ft left on a Portsmouth.. I then kept backing off the tension until she was shooting central, which resulted in the button being so soft it is moving under the clicker pressure.
Has anyone expericed this before? Is it a case of moving centre shot out to enable the tension to be increased? I thought moving to the left would make the arrow impact left though?
I guess the other option is to move the sight pin out to the left and then increase tension to get the impacts central?
She's an experienced shooter, doing 550 portsmouths. She is quite small, so shoots 40lb Hoyt limb she but only draws 32lb. She is currently shooting ACC's in1500 spine..
we checked centre shot and sight positioning, all fine. Started with the button at a stiff setting, arrows 2ft left on a Portsmouth.. I then kept backing off the tension until she was shooting central, which resulted in the button being so soft it is moving under the clicker pressure.
Has anyone expericed this before? Is it a case of moving centre shot out to enable the tension to be increased? I thought moving to the left would make the arrow impact left though?
I guess the other option is to move the sight pin out to the left and then increase tension to get the impacts central?